eCube - darmowy katalog produktów elektrotechnicznych

TECHNICAL DATA MEASURED VALUE Two-state signal Pulses BINARY INPUT Parameters of the voltage contact „L“ level input voltage:< 0,4 V(*); „H“ level input voltage:> 2 V; Minimum voltage applicable:0 V; Maximum voltage applicable:+30 V DC Parameters of the voltage-free contact Contact resistance in „switched-on“ state:< 10 kOhm; Contact resistance in the „switched-off“ state:> 300 kOhm; Contact voltage in the „switched-off“ state: ca 3 V; Minimum state duration necessary for latching the state:1s COUNTER INPUT Counter parameters Range 24 bits (16 777 215), the possibility of letting the counter overflow Maximum pulse frequency configured for voltage input - max. 5kHz configured for a voltage-free or open-collector transistor - max. 200Hz

TECHNICAL DATA MEASURED VALUE Temperature TEMPERATURE SENSOR - INTERNAL PROBE Measuring range -30 to +70 °C Accuracy ±0.4°C; Resolution 0.1 °C Response time of temperature measurement (temperature step 20°C, air flow approximately 1m/s) t63 < 6 minutes; t90 < 15 minutes TEMPERATURE SENSOR - EXTERNAL PROBE PT1000 Measuring range -200 to +260 °C Accuracy ±0.2°C; ±0,2 % of the measurement value in a range of +100 to +260 °C Resolution 0.1 °C Response time t90 of temperature measurement (temperature step 20°C, air flow approximately 1m/s) according to the connected probe TEMPERATURE SENSOR - THERMOCOUPLE TYPE B, J, K, N, S, T Measuring range according to the connected thermocouple Accuracy ±0,4°C Resolution 0,1 °C Response time according to the connected thermocouple

AIRDOS is an airborne cosmic radiation dosimeter and spectrometer unit. It is intended for long-term measurement of cosmic radiation and dosimetry in mixed ionizing radiation fields on board aircraft. The instrument is designed primarily for the dosimetry of cabin crew and flight attendants of commercial flights. Thanks to its design of detachable data storage and power source from accumulators, the required maintenance time is minimal. The calibrated AIRDOS04 detector can be placed on-board continuously and it is only necessary to replace the accumulator/storage module.